FILTER4GOOD.COM

Drinking Water System Faucet This deluxe drinking faucet is designed for use in mounting holes up to 1 1/2" in diameter. The materials, combined with the traditional and modern techniques used in these lead-free solid brass faucets production are of the highest quality exceeding the usual industry standards. The ceramic-disc valve is designed to exceed 450,000 trouble-free revolutions - approximately 50 years of normal use. STEP1. Assemble Top Parts Slip Finished flange up threaded shank, followed by rubber gasket. STEP 2. Insert Into Sink Mounting Hole With finished flange and rubber gasket assembled, insert threaded shank of faucet down through mounting hole. STEP 3. Tighten From Below Deck From underside of sink, slip unfinished brass flange (same size as top flange, but unfinished) up threaded shank of faucet and tighten in place with mounting nut. (Be sure to give faucet proper alignment on top before final tightening.) STEP 4. Make Supply Attachment a) Slip compression nut over end of 1/4" o.d. supply tube, threads facing end. Press ferrule onto end of tube. Insert tube into end of threaded faucet shank and tighten compression nut. b) NOTE: If supplied with quick-connect faucet connection, thread quick connect faucet connection onto faucet shank. Cut copper or plastic tubing squarely with no burred edges. Insert into faucet connection as far as it will go. If you need to remove tubing, push back on dark gray ring. Use locking clip if required. STEP 5. Check For Leaks Turn on supply stop valve feeding faucet. Check for leaks at compression connection. Apply additional tightening, if necessary. Shut off supply stop valve feeding faucet. Loosen screw and remove handle and sleeve. Using wrench, remove and replace ceramic cartridge. * COMPLIES WITH NSF 61.9 * Solid lead-free brass body 2.2 GPM flow rate Quarter turn ceramic disk valve Spout swivels through 360 degrees Lifetime drip-free warranty Installs on 1/2 in. or standard sink hole on either side of the main faucet